Marine mooring bollards
          Cell rubber fender
          Cone rubber fender
          Arch rubber fender
          Cylindrical rubber fender
          Element rubber fender
          Marine boat fender
          D rubber fender
          Square rubber fender
          Wing-D rubber fender
          Pneumatic marine fender
          Foam filled fenders
          Roller dock fender
          Sliding dock fender
          More
 
  News Center
Cylindrical fender installation method

It is essential that the anchor bolts are accurately located prior to installation. There are there main types of installation:

1 New concrete with cast in anchors

2 Steel structures with bolted connections

3 Existing concrete with resin anchors

Whichever type of installation you have, an anchor bolt template will be the most accurate method of locating anchors either in groups or combination. A template should be requested at the time of order enquiry.

1.Chain plate attachment

Prior to installing cylindrical fender, it is advisable that the ancillary components such as chains brackets are installed.

2.Preparation of fender

Prior to unloading of the fender components, it is advisable to prepare a suitable hard, flat surface to lay out the cylindrical rubber fender. Cylindrical rubber Fender can take up quite a large area and it is worth considering this beforehand to allow access for cranes and personnel.

3.Sling attachment for lifting

When ready, a sling can be used to lift cylindrical rubber fender, always check the weight before commencing.

4.Lifting of fender

For easy of installation, the support chain or internal bar can be located in the bore of cylindrical rubber fender to simplify final assembly.

Ensure that the chain will not drop or fall out during lifting by restraining it.

 

5. Fender attachment

Before attachment of the cylindrical fender, always ensure that adequate and safe access has been provide for all instances including inter tidal. Care should be taken when lifting the cylindrical fender into position to avoid damage to the rubber.

6. It is recommended that the carne should support the fender weight prior to fitting of the fender chains as this will make it easier to attach the chains. After the chains have been attached the crane can release, the load and the sling can be removed.

 

 

Copyright(C)2017 , Yantai Defender Maritime Co.,Ltd. All Rights Reserved.  Supported by  ChemNet  ChinaChemNet Toocle Copyright Notice Admin